The toe kick panel removed from the bottom of a dishwasher, a flashlight beam on a shallow plastic base pan with a small float switch in one corner.

Bertazzoni dishwasher
showing F1

F1 is Bertazzoni's overflow alarm.

(844) 430-4286

Mon–Sat, 8am–8pm

  • Leak detected
  • Leak and seal repair
  • Source: Bertazzoni

Book a visit

Three short steps, about a minute.

or call (844) 430-4286

Before you book,
in this order.

Each step comes from Bertazzoni's own guidance for F1 on its dishwashers. Follow it to the end: the last card says whether this is a visit.

01

Unplug the dishwasher and close the water tap.

02

Book a visit; the manual's next step is to contact service.

Still there?

It usually turns into leak and seal repair. Book with the code and the model number.

What not to do

F1 is not a drain warning; the drain code on this model is F2.

What you may
notice with it.

The dishwasher problem F1 tends to arrive with. Answer these at the dishwasher before anyone is booked.

All problems

Where F1 usually leads

Leak and seal repair.

Door gasket, hose or pump seal leak · low.

In Bertazzoni's own words

Overflow
Bertazzoni DW24T3IXT/26 - DW24T3IPT/26 User and Maintenance Manual, table of automatic warnings (us.bertazzoni.com PDF) Bertazzoni DW24T3IXT/26 - DW24T3IPT/26 User and Maintenance Manual, table of automatic warnings (us.bertazzoni.com PDF)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Bertazzoni 24-inch dishwashers DW24T3IXT/26 and DW24T3IPT/26, from the English section of their User and Maintenance Manual.

Bertazzoni F1 dishwasher repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family unloading clean plates from an open dishwasher together in a bright contemporary kitchen, a child handing a plate to a parent
For the heart of your home.

Questions
about F1.

Can I clear F1 myself?
Unplug the dishwasher and close the water tap. If it comes back, it needs a visit.
What should I do first when my Bertazzoni shows F1?
Pull the plug and shut the water tap, as the manual instructs for its overflow alarm. After that, the next step Bertazzoni names is service.
Can I restart my Bertazzoni after an F1 overflow alarm?
The manual gives no restart step for F1, only unplugging, closing the tap and contacting service. Keep it off until it has been checked.

Back to your everyday

Still showing F1?

Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.

(844) 430-4286 Schedule a repair