The looped heating element running around the floor of an empty dishwasher tub, stainless walls reflecting a soft light.

SKS dishwasher
showing HE

SKS reports a heater circuit failure.

(844) 430-4286

Mon–Sat, 8am–8pm

  • Heating
  • Heating and drying repair
  • Source: SKS

Book a visit

Three short steps, about a minute.

or call (844) 430-4286

Before you book,
in this order.

Each step comes from SKS's own guidance for HE on its dishwashers. Follow it to the end: the last card says whether this is a visit.

01

Note the code and when it appeared.

02

Stop using heated or sanitizing cycles until it is checked.

03

Book a visit; SKS gives no owner fix for HE.

Still there?

It usually turns into heating and drying repair. Book with the code and the model number.

What not to do

Do not expect a reset to fix a heater circuit failure. The manual lists no reset step for HE at all.

What you may
notice with it.

The dishwasher problems HE tends to arrive with. Answer these at the dishwasher before anyone is booked.

All problems

Where HE usually leads

Heating and drying repair.

Heating element, thermistor or high-limit · moderate.

In SKS's own words

HE Heater circuit failure.
Signature Kitchen Suite SKSDW2401S owner's manual: Error Messages

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. HE is listed in the manuals for the Signature Kitchen Suite 24-inch SKSDW2401S and SKSDW2402P.

SKS HE dishwasher repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family unloading clean plates from an open dishwasher together in a bright contemporary kitchen, a child handing a plate to a parent
For the heart of your home.

Questions
about HE.

Can I clear HE myself?
Note the code and when it appeared. If it comes back, it needs a visit.
Can I reset my SKS to clear HE?
The SKS manual gives no reset procedure for HE and sends the heater circuit failure to service. Write down the code and when it showed up so the technician has that information.
Is it fine to keep running sanitize loads on an SKS with HE?
Hold off on heated and sanitizing programs until the heater circuit has been checked, since the heat those cycles depend on is what the code questions. Ordinary loads will not tell you whether it has recovered.

Back to your everyday

Still showing HE?

Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.

(844) 430-4286 Schedule a repair