Gaggenau dishwasher
showing E:9001
E:9001 means the voltage reaching the dishwasher is too low.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: Gaggenau
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E:9001
actually means.
E:9001 means the voltage reaching the dishwasher is too low. The manual says there is no problem with the appliance.
Gaggenau dishwasher display
What to do when E:9001 shows on the dishwasherKind of codeMode, not a failure
A setting someone turned on, or a reminder the machine shows on purpose — a control lock, a demo mode, a rinse-aid prompt. Nothing is broken and no part is needed.
Usually leads toNo repair
Call an electrician to check the voltage and the electrical installation.
Shows up asDishwasher Not Starting
The door is shut and a cycle is chosen, but nothing happens, or the lights come on and it will not run.
MakeGaggenau
Top-tier built-in dishwashers from the BSH family, often installed fully integrated.
SourceGaggenau DF480700 Use and Care Manual (en-us), Troubleshooting (media3.gaggenau.com PDF)
Gaggenau DF480700, per the troubleshooting table of its US manual.
Before you book,
in this order.
Each step comes from Gaggenau's own guidance for E:9001 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
Call an electrician to check the voltage and the electrical installation.
Book a visit only if the supply checks out and E:9001 remains.
Cleared?
No part needed replacing. If the next full cycle still stops partway or leaves water in the tub, treat that as a new problem.
What not to do
E:9001 is not a control board error; it reports on the building's power.
What you may
notice with it.
The dishwasher problems E:9001 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Dishwasher Not Starting
5 causes, cheapest first
No repair indicated
Nothing to repair.
A setting someone turned on, or a reminder the machine shows on purpose — a control lock, a demo mode, a rinse-aid prompt. Nothing is broken and no part is needed.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesGaggenau
dishwashers.
Top-tier built-in dishwashers from the BSH family, often installed fully integrated.
Gaggenau dishwasher repair
In Gaggenau's own words
Power voltage is too low.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Gaggenau DF480700, per the troubleshooting table of its US manual.
Gaggenau E:9001 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E:9001.
Can I clear E:9001 myself?
Is my Gaggenau broken when it shows E:9001?
Who should I call first for Gaggenau E:9001?
Back to your everyday
Still showing E:9001?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.