Gaggenau dishwasher
showing E:6103
E:6103 with water left in the tub means the water cannot drain.
Mon–Sat, 8am–8pm
- Drain
- Drain and pump repair
- Source: Gaggenau
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E:6103
actually means.
E:6103 with water left in the tub means the water cannot drain. The manual lists a knockout plug still in a new garbage disposal, a kinked drain hose, a missing high loop, debris washed back into the hose, or a loose or jammed pump cover.
Gaggenau dishwasher display
What to do when E:6103 shows on the dishwasherKind of codeDrain
Water did not leave the tub in the time the control expects. A clogged filter, a kinked hose or a blocked disposal inlet are ruled out before the drain pump.
Usually leads toDrain and pump repair
Water left standing in the tub, cleared by finding where the drain path actually stops.
Shows up asDishwasher Not Draining
Dirty water stays in the bottom of the tub after the cycle ends.
MakeGaggenau
Top-tier built-in dishwashers from the BSH family, often installed fully integrated.
SourceGaggenau DF480700 Use and Care Manual (en-us), Troubleshooting (media3.gaggenau.com PDF)
Gaggenau DF480700 as covered by the 9001798908 manual.
Before you book,
in this order.
Each step comes from Gaggenau's own guidance for E:6103 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
If the dishwasher drains into a new garbage disposal, confirm its knockout plug was removed.
Check the drain hose for kinks and make sure it rises in a high loop under the counter.
Clean the drain pump and snap its cover back into place.
Book a visit if water still stands after those checks.
What not to do
The manual does not treat E:6103 as an appliance error; most of its causes lie in the installation.
What you may
notice with it.
The dishwasher problems E:6103 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Dishwasher Not Draining
6 causes, cheapest first
Where E:6103 usually leads
Drain and pump repair.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesGaggenau
dishwashers.
Top-tier built-in dishwashers from the BSH family, often installed fully integrated.
Gaggenau dishwasher repair
In Gaggenau's own words
Not an appliance error. Garbage disposal is still plugged or the drain hose is kinked.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Gaggenau DF480700 as covered by the 9001798908 manual.
Gaggenau E:6103 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E:6103.
Can I clear E:6103 myself?
Is Gaggenau E:6103 a problem with the dishwasher itself?
What is the high loop mentioned for Gaggenau E:6103?
Back to your everyday
Still showing E:6103?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.