Electrolux dishwasher
showing i20
For an Electrolux, i20 reports a drain that did not complete: water stayed in the tub past the drain step.
Mon–Sat, 8am–8pm
- Drain
- Drain and pump repair
- Source: Electrolux
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What i20
actually means.
For an Electrolux, i20 reports a drain that did not complete: water stayed in the tub past the drain step.
Electrolux dishwasher display
What to do when i20 shows on the dishwasherKind of codeDrain
Water did not leave the tub in the time the control expects. A clogged filter, a kinked hose or a blocked disposal inlet are ruled out before the drain pump.
Usually leads toDrain and pump repair
Water left standing in the tub, cleared by finding where the drain path actually stops.
Shows up asDishwasher Not Draining
Dirty water stays in the bottom of the tub after the cycle ends.
MakeElectrolux
Built-in dishwashers from the Electrolux group, sharing a family of parts with its sister brands.
SourceElectrolux owner support: Dishwasher Error Code i20
Electrolux's US owner-support articles for its dishwashers; Frigidaire publishes the same list for its own models.
Before you book,
in this order.
Each step comes from Electrolux's own guidance for i20 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
Clean the glass trap and filter at the bottom of the tub.
Make sure the drain hose is neither obstructed nor squeezed, and loops up at least 32 inches from the floor.
On a new disposer hookup, check that the knockout plug is out.
Reset with the Cancel button or the breaker, and book a visit if i20 comes back.
What not to do
An Electrolux showing i20 has not necessarily lost its pump; the hose height and the trap come first.
What you may
notice with it.
The dishwasher problem i20 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Where i20 usually leads
Drain and pump repair.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesElectrolux
dishwashers.
Built-in dishwashers from the Electrolux group, sharing a family of parts with its sister brands.
Electrolux dishwasher repair
In Electrolux's own words
Make sure the drain hose is at the correct height a min. of 32” from the floor.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Electrolux's US owner-support articles for its dishwashers; Frigidaire publishes the same list for its own models.
Electrolux i20 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about i20.
Can I clear i20 myself?
How high should the drain hose be for Electrolux i20?
How do I reset an Electrolux after i20?
Back to your everyday
Still showing i20?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.