Frigidaire dishwasher
showing i20
Frigidaire's i20 says the dishwasher did not drain properly, so water was left in the tub at the end of a drain step.
Mon–Sat, 8am–8pm
- Drain
- Drain and pump repair
- Source: Frigidaire
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What i20
actually means.
Frigidaire's i20 says the dishwasher did not drain properly, so water was left in the tub at the end of a drain step.
Frigidaire dishwasher display
What to do when i20 shows on the dishwasherKind of codeDrain
Water did not leave the tub in the time the control expects. A clogged filter, a kinked hose or a blocked disposal inlet are ruled out before the drain pump.
Usually leads toDrain and pump repair
Water left standing in the tub, cleared by finding where the drain path actually stops.
Shows up asDishwasher Not Draining
Dirty water stays in the bottom of the tub after the cycle ends.
MakeFrigidaire
Widely installed, value-focused built-in dishwashers from the Electrolux group.
SourceFrigidaire owner support: Dishwasher Error Code i20
Frigidaire's owner-support articles for its dishwashers with a display; models without a display signal some of these events with flashing lights instead.
Before you book,
in this order.
Each step comes from Frigidaire's own guidance for i20 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
If the dishwasher is newly installed on a disposer, confirm the knockout plug inside the disposer was removed.
Check that the drain hose is not blocked, pinched, and that it rises to at least 32 inches above the floor.
Clear the glass trap and filter, then reset by holding Cancel or by switching the breaker off.
Book a visit if i20 returns with a clear hose and a clean filter.
What not to do
i20 concerns water leaving the tub, not water coming in.
What you may
notice with it.
The dishwasher problems i20 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Dishwasher Not Draining
6 causes, cheapest first
Where i20 usually leads
Drain and pump repair.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesFrigidaire
dishwashers.
Widely installed, value-focused built-in dishwashers from the Electrolux group.
Frigidaire dishwasher repair
In Frigidaire's own words
Error Code i20 indicates that the dishwasher is not draining properly.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Frigidaire's owner-support articles for its dishwashers with a display; models without a display signal some of these events with flashing lights instead.
Frigidaire i20 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about i20.
Can I clear i20 myself?
Why does a new Frigidaire show i20 on its first wash?
Can I reset Frigidaire i20 without calling anyone?
Back to your everyday
Still showing i20?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.