The toe kick panel removed from the bottom of a dishwasher, a flashlight beam on a shallow plastic base pan with a small float switch in one corner.

Miele dishwasher
showing F70

F70 means the Waterproof system has reacted.

(844) 430-4286

Mon–Sat, 8am–8pm

  • Leak detected
  • Leak and seal repair
  • Source: Miele

Book a visit

Three short steps, about a minute.

or call (844) 430-4286

Before you book,
in this order.

Each step comes from Miele's own guidance for F70 on its dishwashers. Follow it to the end: the last card says whether this is a visit.

01

Close the faucet that feeds the dishwasher.

02

Turn the machine off and pull the plug; the drain pump then stops.

03

Book a visit so the leak can be found before the dishwasher is used again.

Still there?

It usually turns into leak and seal repair. Book with the code and the model number.

What not to do

F70 is not something to clear and forget. Miele's instruction is to shut off the water and call for service.

What you may
notice with it.

The dishwasher problem F70 tends to arrive with. Answer these at the dishwasher before anyone is booked.

All problems

Where F70 usually leads

Leak and seal repair.

Door gasket, hose or pump seal leak · low.

In Miele's own words

The water protection system has reacted. The current program is canceled and the drain pump switches on.
Miele USA support: F70 on a dishwasher (Wayback Machine copy of mieleusa.com, May 2026; the live page refuses automated reads)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Miele dishwashers fitted with the Waterproof system.

Miele F70 dishwasher repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family unloading clean plates from an open dishwasher together in a bright contemporary kitchen, a child handing a plate to a parent
For the heart of your home.

Questions
about F70.

Can I clear F70 myself?
Close the faucet that feeds the dishwasher. If it comes back, it needs a visit.
Why does my Miele keep draining after F70 appears?
When the Waterproof system reacts, the machine abandons the program and sets the drain pump running on purpose. Close the faucet that supplies it, then unplug the dishwasher and the pump will stop.
Is it safe to run my Miele again once F70 is gone?
Not until the source of the water has been found, since the system only reacts when something has leaked. Miele's guidance is to keep the water off and have the machine serviced first.

Back to your everyday

Still showing F70?

Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.

(844) 430-4286 Schedule a repair