Asko dishwasher
showing F12
F12 means water is not coming in properly.
Mon–Sat, 8am–8pm
- Water supply
- Fill and water valve repair
- Source: ASKO
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F12
actually means.
F12 means water is not coming in properly. Asko asks you to confirm the supply valve is open and says the house pressure must be between 4.2 and 140 psi.
ASKO dishwasher display
What to do when F12 shows on the dishwasherKind of codeWater supply
Not enough water arrived, or it arrived too slowly. The supply valve under the sink and the inlet screen are checked before the fill valve itself.
Usually leads toFill and water valve repair
A dishwasher that will not fill, fills too little, or keeps filling, traced through the valve, the float and the supply.
Shows up asDishwasher Not Filling With Water
The cycle starts and hums, but little or no water comes into the tub.
MakeASKO
Scandinavian-designed dishwashers with stainless steel interiors, sold in built-in and panel-ready versions.
SourceAsko DBI786IXXLSSOF.U User Manual, Troubleshooting (PDF on the Gorenje Group document server, linked from us.asko.com)
Asko DBI675, DBI776 and DBI786; on these models F67 is a second water inlet code with the same advice.
Before you book,
in this order.
Each step comes from ASKO's own guidance for F12 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
Open the water supply valve fully.
Press any button to clear the message, then start the program again.
If the valve is open and F12 returns, book a visit.
Still there?
It usually turns into fill and water valve repair. Book with the code and the model number.
What not to do
F12 is not the same as F40: with F12 too little water arrives, with F40 water arrives when it should not.
What you may
notice with it.
The dishwasher problems F12 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Where F12 usually leads
Fill and water valve repair.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesASKO
dishwashers.
Scandinavian-designed dishwashers with stainless steel interiors, sold in built-in and panel-ready versions.
ASKO dishwasher repair
In ASKO's own words
The water pressure must be between 4.2-140 psi (0.03-1.0 MPa).
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Asko DBI675, DBI776 and DBI786; on these models F67 is a second water inlet code with the same advice.
ASKO F12 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F12.
Can I clear F12 myself?
Can low house water pressure trigger Asko F12?
How do I clear F12 on my Asko once the valve is open?
Back to your everyday
Still showing F12?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.