Fisher & Paykel dishwasher
showing A1
A DishDrawer drawer did not get the water it needed to wash.
Mon–Sat, 8am–8pm
- Water supply
- Fill and water valve repair
- Source: Fisher & Paykel
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What A1
actually means.
A DishDrawer drawer did not get the water it needed to wash. The drawer beeps and its lights flash until the alert is cleared.
Fisher & Paykel dishwasher display
What to do when A1 shows on the dishwasherKind of codeWater supply
Not enough water arrived, or it arrived too slowly. The supply valve under the sink and the inlet screen are checked before the fill valve itself.
Usually leads toFill and water valve repair
A dishwasher that will not fill, fills too little, or keeps filling, traced through the valve, the float and the supply.
Shows up asDishwasher Not Filling With Water
The cycle starts and hums, but little or no water comes into the tub.
MakeFisher & Paykel
The maker of the DishDrawer, alongside conventional built-in dishwashers.
SourceFisher & Paykel user guide, Series 7 DishDrawer (DD24DCTX9 family): 'A' codes
DishDrawer dishwashers, Series 7, 9 and 11. Where a DishDrawer panel has no number display, A1 is shown as the light pattern the guide prints beside it.
Before you book,
in this order.
Each step comes from Fisher & Paykel's own guidance for A1 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
Check that the water supply to the dishwasher is turned on.
Press Power once to stop the beeping and again to clear the alert, then press Start to carry on with the wash.
If A1 keeps returning with the water on, book a visit.
Still there?
It usually turns into fill and water valve repair. Book with the code and the model number.
What not to do
Do not assume both drawers have the problem. On a double DishDrawer each drawer reports its own code, and the other one can keep working.
What you may
notice with it.
The dishwasher problems A1 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Where A1 usually leads
Fill and water valve repair.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesFisher & Paykel
dishwashers.
The maker of the DishDrawer, alongside conventional built-in dishwashers.
Fisher & Paykel dishwasher repair
In Fisher & Paykel's own words
A1 Water supply fault.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. DishDrawer dishwashers, Series 7, 9 and 11. Where a DishDrawer panel has no number display, A1 is shown as the light pattern the guide prints beside it.
Fisher & Paykel A1 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about A1.
Can I clear A1 myself?
How do I stop the beeping for Fisher & Paykel A1?
Does A1 on one DishDrawer affect the other drawer?
Back to your everyday
Still showing A1?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.