KitchenAid dishwasher
showing F6E3
The sensing system has found foam in the tub.
Mon–Sat, 8am–8pm
- Wash motor and circulation
- Wash motor and circulation
- Source: KitchenAid
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F6E3
actually means.
The sensing system has found foam in the tub. Suds interfere with pumping water and can stop the dishwasher from filling correctly.
KitchenAid dishwasher display · also shown as Clean light: 6 blinks, pause, 3 blinks
What to do when F6E3 shows on the dishwasherKind of codeWash motor and circulation
The pump that pushes water through the spray arms is not running at the speed the control expects. Debris in the chopper or the pump is checked before the motor.
Usually leads toWash motor and circulation
The motor that throws the water at the dishes, and the most expensive part most dishwashers have.
Shows up asDishwasher Not Cleaning Dishes
Dishes come out with food stuck on, gritty film or spots that a full cycle should have removed.
MakeKitchenAid
Built-in dishwashers from Whirlpool Corporation known for their third racks and stainless interiors.
SourceKitchenAid product help: F6E3 error code
From KitchenAid's own product-help pages for its dishwashers; on panels without a readout the same code is flashed on the Clean light.
Before you book,
in this order.
Each step comes from KitchenAid's own guidance for F6E3 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
Scoop out as much foam as you can with a plastic cup.
Take out the dishes, pour two or three tablespoons of vegetable oil into the tub floor and run a full cycle with nothing in it.
Follow with a second empty cycle using normal dishwasher detergent.
Book a visit if F6E3 returns with only dishwasher detergent in use.
Still there?
It usually turns into wash motor and circulation. Book with the code and the model number.
What not to do
F6E3 is rarely a broken part. Laundry detergent, hand soap or a rinse-aid cap left off are what KitchenAid names.
What you may
notice with it.
The dishwasher problems F6E3 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Dishwasher Not Cleaning Dishes
5 causes, cheapest first
Where F6E3 usually leads
Wash motor and circulation.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesKitchenAid
dishwashers.
Built-in dishwashers from Whirlpool Corporation known for their third racks and stainless interiors.
KitchenAid dishwasher repair
In KitchenAid's own words
Potential Cause: Excessive Suds
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. From KitchenAid's own product-help pages for its dishwashers; on panels without a readout the same code is flashed on the Clean light.
KitchenAid F6E3 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F6E3.
Can I clear F6E3 myself?
Can F6E3 on a KitchenAid happen with no broken part at all?
What does the vegetable oil step do for F6E3 on a KitchenAid?
Back to your everyday
Still showing F6E3?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.