KitchenAid dishwasher
showing F8E5
The water valve is stuck in the open position on this KitchenAid, letting water in beyond what the cycle asked for.
Mon–Sat, 8am–8pm
- Water supply
- Fill and water valve repair
- Source: KitchenAid
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F8E5
actually means.
The water valve is stuck in the open position on this KitchenAid, letting water in beyond what the cycle asked for.
KitchenAid dishwasher display · also shown as Clean light: 8 blinks, pause, 5 blinks
What to do when F8E5 shows on the dishwasherKind of codeWater supply
Not enough water arrived, or it arrived too slowly. The supply valve under the sink and the inlet screen are checked before the fill valve itself.
Usually leads toFill and water valve repair
A dishwasher that will not fill, fills too little, or keeps filling, traced through the valve, the float and the supply.
Shows up asDishwasher Leaking Water
Water on the kitchen floor during or after a cycle, from the door, the corners or underneath.
MakeKitchenAid
Built-in dishwashers from Whirlpool Corporation known for their third racks and stainless interiors.
SourceKitchenAid product help: F8E5 error code
From KitchenAid's own product-help pages for its dishwashers; on panels without a readout the same code is flashed on the Clean light.
Before you book,
in this order.
Each step comes from KitchenAid's own guidance for F8E5 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
Close the under-sink supply first, if you can reach it.
Press Cancel once to stop the alarm, shut the door and keep the unit powered.
Only if the supply cannot be closed, switch off the dishwasher's power.
Book a visit for the fill valve; running more cycles will not free it.
Still there?
It usually turns into fill and water valve repair. Book with the code and the model number.
What not to do
Opening the door to watch the water rise is the wrong instinct here; KitchenAid's steps keep the door closed.
What you may
notice with it.
The dishwasher problem F8E5 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Where F8E5 usually leads
Fill and water valve repair.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesKitchenAid
dishwashers.
Built-in dishwashers from Whirlpool Corporation known for their third racks and stainless interiors.
KitchenAid dishwasher repair
In KitchenAid's own words
Potential Cause: Fill Valve Stuck Open
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. From KitchenAid's own product-help pages for its dishwashers; on panels without a readout the same code is flashed on the Clean light.
KitchenAid F8E5 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F8E5.
Can I clear F8E5 myself?
Should I unplug my KitchenAid when F8E5 shows up?
Will F8E5 on a KitchenAid clear if I run another cycle?
Back to your everyday
Still showing F8E5?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.