The bottom of a dishwasher tub with the lower rack removed, cloudy water standing around the cylindrical filter and the spray arm above it.

Viking dishwasher
showing 3-3

Viking's drain pump error, shown as three flashes on each light.

(844) 430-4286

Mon–Sat, 8am–8pm

  • Drain
  • Drain and pump repair
  • Source: Viking

Book a visit

Three short steps, about a minute.

or call (844) 430-4286

Before you book,
in this order.

Each step comes from Viking's own guidance for 3-3 on its dishwashers. Follow it to the end: the last card says whether this is a visit.

01

Press and hold Start for 4 seconds to reset the unit, and run a cycle.

02

Watch whether the tub empties at the end.

03

If 3-3 comes back, book a visit for the drain pump.

Still there?

It usually turns into drain and pump repair. Book with the code and the model number.

What not to do

Do not confuse 3-3 with 1-5. 1-5 is a drain error with outside checks to do; 3-3 names the pump itself.

What you may
notice with it.

The dishwasher problems 3-3 tends to arrive with. Answer these at the dishwasher before anyone is booked.

All problems

Where 3-3 usually leads

Drain and pump repair.

Drain pump or drain hose · low.

In Viking's own words

Drain Pump Error Reset Unit and try again. If problem persists, contact service.
Viking 451 Series built-in dishwashers use & care manual: troubleshooting code table

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. The 3-3 pattern is in the tables for Viking 451, 324 and later 450 Series built-in dishwashers.

Viking 3-3 dishwasher repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family unloading clean plates from an open dishwasher together in a bright contemporary kitchen, a child handing a plate to a parent
For the heart of your home.

Questions
about 3-3.

Can I clear 3-3 myself?
Press and hold Start for 4 seconds to reset the unit, and run a cycle. If it comes back, it needs a visit.
How is 3-3 different from 1-5 on my Viking?
The 1-5 pattern is a general drain error with checks outside the machine, while 3-3 names the drain pump. After a reset, check that no water is left standing when the cycle finishes.
What happens if 3-3 returns on my Viking?
A second 3-3 after a reset points to the drain pump, and that needs a visit. There is no owner check beyond the reset.

Back to your everyday

Still showing 3-3?

Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.

(844) 430-4286 Schedule a repair