GE dishwasher
showing PrS
The pressure sensor that tracks the water level is sending the control a reading it cannot use, so a cycle either will not start or cancels itself.
Mon–Sat, 8am–8pm
- Sensor circuit
- Controls and sensors
- Source: GE
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What PrS
actually means.
The pressure sensor that tracks the water level is sending the control a reading it cannot use, so a cycle either will not start or cancels itself.
GE dishwasher display
What to do when PrS shows on the dishwasherKind of codeSensor circuit
A temperature, turbidity or water-level sensor reporting a value outside its range, or the wiring to it. The reading is measured with a meter before any part is ordered.
Usually leads toControls and sensors
Dead panels, stuck cycles and blinking lights, separated into board, keypad, sensor and wiring before a part is ordered.
Shows up asDishwasher Not Heating Water
Dishes and the tub are cool at the end of the cycle, and grease stays on plates.
MakeGE
Everyday built-in dishwashers from GE Appliances, found in a large share of American homes.
SourceGE Appliances support: dishwasher error and function codes
Shown on GE models whose control reads the water level through a pressure sensor.
Before you book,
in this order.
Each step comes from GE's own guidance for PrS on its dishwashers. Follow it to the end: the last card says whether this is a visit.
Cut power at the breaker for a minute or two and restore it; GE says this sometimes clears a code.
Try one cycle to see whether it now runs through.
If PrS stays, book a visit — GE points at the harness or the sensor.
What not to do
Do not keep cycling power over and over. GE calls this most likely a wiring or sensor issue, and repeated resets will not repair either.
What you may
notice with it.
The dishwasher problems PrS tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Dishwasher Not Heating Water
5 causes, cheapest first
Where PrS usually leads
Controls and sensors.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesGE
dishwashers.
Everyday built-in dishwashers from GE Appliances, found in a large share of American homes.
GE dishwasher repair
In GE's own words
Indicates the pressure sensor is sending an invalid signal to the control. Cannot start cycle or it will cancel.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Shown on GE models whose control reads the water level through a pressure sensor.
GE PrS dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about PrS.
Can I clear PrS myself?
Will cycling the power fix GE PrS?
What does GE PrS mean for my cycle?
Back to your everyday
Still showing PrS?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.