A small sensor mounted on the underside of a dishwasher tub beside the sump, its wires running neatly to a connector, seen from below with the kick panel off.

LG dishwasher
showing tE

The thermistor that reads water temperature reported a problem, or the water went above 194°F.

(844) 430-4286

Mon–Sat, 8am–8pm

  • Sensor circuit
  • Controls and sensors
  • Source: LG

Book a visit

Three short steps, about a minute.

or call (844) 430-4286

Before you book,
in this order.

Each step comes from LG's own guidance for tE on its dishwashers. Follow it to the end: the last card says whether this is a visit.

01

Turn the machine off and cut the breaker for a short while, then try one cycle.

02

Leave the door closed while it runs so the reading is not disturbed.

03

If tE persists, book a visit to have the thermistor and its wiring tested.

Still there?

It usually turns into controls and sensors. Book with the code and the model number.

What not to do

Do not read tE as a heating element failure. LG points at the temperature sensor, and the element may be fine.

What you may
notice with it.

The dishwasher problems tE tends to arrive with. Answer these at the dishwasher before anyone is booked.

All problems

Where tE usually leads

Controls and sensors.

Control board, keypad or sensor · moderate.

In LG's own words

This will occur if the water temperature is above 194 degrees, or if there is a problem with the thermistor.
LG US support: Dishwasher error code list (Wayback copy, 11 Dec 2025)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Shown as tE on LG dishwasher displays.

LG tE dishwasher repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family unloading clean plates from an open dishwasher together in a bright contemporary kitchen, a child handing a plate to a parent
For the heart of your home.

Questions
about tE.

Can I clear tE myself?
Turn the machine off and cut the breaker for a short while, then try one cycle. If it comes back, it needs a visit.
Should I replace the heating element when my LG shows tE?
Not on this code, because tE is about the temperature sensor, the thermistor, and the element can be perfectly good. The code also shows if the water got hotter than 194°F.
How should I run the test cycle after tE on an LG?
Cut the breaker briefly, then start one cycle and leave the door shut until it finishes so the sensor reads undisturbed water. If tE shows up anyway, a technician measures the sensor and the wires that feed it.

Back to your everyday

Still showing tE?

Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.

(844) 430-4286 Schedule a repair