Whirlpool dishwasher
showing F1E2
The main control lost communication with the rest of the electronics.
Mon–Sat, 8am–8pm
- Communication
- Controls and sensors
- Source: Whirlpool
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F1E2
actually means.
The main control lost communication with the rest of the electronics. Whirlpool gives F2E2 the same label.
Whirlpool dishwasher display · also shown as Clean light: 1 blinks, pause, 2 blinks
What to do when F1E2 shows on the dishwasherKind of codeCommunication
The control board and the user panel on the door stopped talking to each other. The ribbon cable through the door hinge is checked before either board.
Usually leads toControls and sensors
Dead panels, stuck cycles and blinking lights, separated into board, keypad, sensor and wiring before a part is ordered.
Shows up asDishwasher Control Panel Not Responding
Buttons do nothing, only some keys work, or the display stays dark or frozen.
MakeWhirlpool
Everyday built-in dishwashers from one of the largest appliance makers in the US.
SourceWhirlpool product help: F1E2 error code
Listed on Whirlpool's product-help site for its current built-in dishwashers; models without a display blink it on the Clean light.
Before you book,
in this order.
Each step comes from Whirlpool's own guidance for F1E2 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
Switch the breaker off for 30 seconds, or unplug the unit, then bring power back.
Try a cycle; a single glitch usually clears here.
Book a visit if the code comes back; the connections between the boards are checked before a board is ordered.
What not to do
Do not swap the control panel on the strength of F1E2 alone. The link between boards is suspected before either board.
What you may
notice with it.
The dishwasher problem F1E2 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Where F1E2 usually leads
Controls and sensors.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesWhirlpool
dishwashers.
Everyday built-in dishwashers from one of the largest appliance makers in the US.
Whirlpool dishwasher repair
In Whirlpool's own words
Potential Cause: Main Control Communication Error
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Listed on Whirlpool's product-help site for its current built-in dishwashers; models without a display blink it on the Clean light.
Whirlpool F1E2 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F1E2.
Can I clear F1E2 myself?
Is F1E2 the same as F2E2 on a Whirlpool?
Should I replace the control panel for F1E2 on my Whirlpool?
Back to your everyday
Still showing F1E2?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.