Whirlpool dishwasher
showing F8E5
The fill valve is not closing, so water keeps coming in when the control has asked it to stop.
Mon–Sat, 8am–8pm
- Water supply
- Fill and water valve repair
- Source: Whirlpool
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F8E5
actually means.
The fill valve is not closing, so water keeps coming in when the control has asked it to stop. Left alone this can overfill the tub.
Whirlpool dishwasher display · also shown as Clean light: 8 blinks, pause, 5 blinks
What to do when F8E5 shows on the dishwasherKind of codeWater supply
Not enough water arrived, or it arrived too slowly. The supply valve under the sink and the inlet screen are checked before the fill valve itself.
Usually leads toFill and water valve repair
A dishwasher that will not fill, fills too little, or keeps filling, traced through the valve, the float and the supply.
Shows up asDishwasher Leaking Water
Water on the kitchen floor during or after a cycle, from the door, the corners or underneath.
MakeWhirlpool
Everyday built-in dishwashers from one of the largest appliance makers in the US.
SourceWhirlpool product help: F8E5 error code
Listed on Whirlpool's product-help site for its current built-in dishwashers; models without a display blink it on the Clean light.
Before you book,
in this order.
Each step comes from Whirlpool's own guidance for F8E5 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
Turn off the water to the dishwasher at the under-sink valve.
Press Cancel once to stop the tone, then close the door and leave the power on, as Whirlpool instructs.
Cut the power only if the water cannot be shut off.
Book a visit; a valve that sticks open is replaced rather than cleaned.
Still there?
It usually turns into fill and water valve repair. Book with the code and the model number.
What not to do
Pulling the plug is the fallback, not the first move: Whirlpool keeps power on unless the water cannot be stopped.
What you may
notice with it.
The dishwasher problems F8E5 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Dishwasher Leaking Water
6 causes, cheapest first
Where F8E5 usually leads
Fill and water valve repair.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesWhirlpool
dishwashers.
Everyday built-in dishwashers from one of the largest appliance makers in the US.
Whirlpool dishwasher repair
In Whirlpool's own words
Potential Cause: Fill Valve Stuck Open
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Listed on Whirlpool's product-help site for its current built-in dishwashers; models without a display blink it on the Clean light.
Whirlpool F8E5 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F8E5.
Can I clear F8E5 myself?
Should I unplug my Whirlpool when F8E5 appears?
Can the valve be cleaned to fix F8E5 on a Whirlpool?
Back to your everyday
Still showing F8E5?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.