Whirlpool dishwasher
showing F9E2
The control could not run the drain motor the way it expected.
Mon–Sat, 8am–8pm
- Drain
- Drain and pump repair
- Source: Whirlpool
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F9E2
actually means.
The control could not run the drain motor the way it expected. Where F9E1 is about time, F9E2 names the motor itself.
Whirlpool dishwasher display · also shown as Clean light: 9 blinks, pause, 2 blinks
What to do when F9E2 shows on the dishwasherKind of codeDrain
Water did not leave the tub in the time the control expects. A clogged filter, a kinked hose or a blocked disposal inlet are ruled out before the drain pump.
Usually leads toDrain and pump repair
Water left standing in the tub, cleared by finding where the drain path actually stops.
Shows up asDishwasher Not Draining
Dirty water stays in the bottom of the tub after the cycle ends.
MakeWhirlpool
Everyday built-in dishwashers from one of the largest appliance makers in the US.
SourceWhirlpool product help: F9E2 error code
Listed on Whirlpool's product-help site for its current built-in dishwashers; models without a display blink it on the Clean light.
Before you book,
in this order.
Each step comes from Whirlpool's own guidance for F9E2 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
Clear the disposer and the sink drain, then straighten the drain hose behind the unit.
Cut power at the plug or the breaker for 30 seconds to reset the control.
If F9E2 comes back after the reset, book a visit to test the drain motor and its wiring.
What not to do
Do not keep restarting cycles to push the water out; a motor the control cannot drive will not clear with repetition.
What you may
notice with it.
The dishwasher problem F9E2 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Where F9E2 usually leads
Drain and pump repair.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesWhirlpool
dishwashers.
Everyday built-in dishwashers from one of the largest appliance makers in the US.
Whirlpool dishwasher repair
In Whirlpool's own words
Potential Cause: Drain motor error
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Listed on Whirlpool's product-help site for its current built-in dishwashers; models without a display blink it on the Clean light.
Whirlpool F9E2 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F9E2.
Can I clear F9E2 myself?
Will running more cycles push the water out for F9E2 on my Whirlpool?
How is F9E2 different from F9E1 on a Whirlpool?
Back to your everyday
Still showing F9E2?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.