JennAir dishwasher
showing F9E2
JennAir reserves F9E2 for a drain motor error, meaning the control could not drive the pump that empties the tub.
Mon–Sat, 8am–8pm
- Drain
- Drain and pump repair
- Source: JennAir
Book a visit
Three short steps, about a minute.
or call (844) 430-4286
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F9E2
actually means.
JennAir reserves F9E2 for a drain motor error, meaning the control could not drive the pump that empties the tub.
JennAir dishwasher display · also shown as Clean light: 9 blinks, pause, 2 blinks
What to do when F9E2 shows on the dishwasherKind of codeDrain
Water did not leave the tub in the time the control expects. A clogged filter, a kinked hose or a blocked disposal inlet are ruled out before the drain pump.
Usually leads toDrain and pump repair
Water left standing in the tub, cleared by finding where the drain path actually stops.
Shows up asDishwasher Not Draining
Dirty water stays in the bottom of the tub after the cycle ends.
MakeJennAir
Luxury built-in dishwashers from Whirlpool Corporation, offered in panel-ready and finished styles.
SourceJennAir product help: F9E2 error code
Taken from JennAir's product-help pages for its dishwashers; JennAir also describes reading such codes as Clean-light blink counts.
Before you book,
in this order.
Each step comes from JennAir's own guidance for F9E2 on its dishwashers. Follow it to the end: the last card says whether this is a visit.
Check the sink drain and disposer for clogs, and straighten the dishwasher drain hose.
Turn the power off at the breaker for 30 seconds, then on again.
Book a visit if the code is still there after the reset.
What not to do
Bailing water out by hand and restarting will not answer F9E2; the motor circuit needs testing.
What you may
notice with it.
The dishwasher problem F9E2 tends to arrive with. Answer these at the dishwasher before anyone is booked.
All problems
Where F9E2 usually leads
Drain and pump repair.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesJennAir
dishwashers.
Luxury built-in dishwashers from Whirlpool Corporation, offered in panel-ready and finished styles.
JennAir dishwasher repair
In JennAir's own words
Cycle Power, if error returns, schedule service.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Taken from JennAir's product-help pages for its dishwashers; JennAir also describes reading such codes as Clean-light blink counts.
JennAir F9E2 dishwasher repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F9E2.
Can I clear F9E2 myself?
Will bailing out water fix JennAir F9E2?
What should I do if JennAir F9E2 returns after a reset?
Back to your everyday
Still showing F9E2?
Book with the characters exactly as shown, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.